Discharge Instructions: Changing the Dressing on Your Midline Catheter

When to change the dressing

Your healthcare team will tell you when to change your dressing. In general, change your dressing:

• Every 5 to 7 days if you have a transparent dressing

• Every 2 days if you have a gauze dressing

• Any time the dressing becomes loose, dirty, or wet

Preventing infection

A midline catheter can let germs into your body. This can lead to an infection. To prevent infection, it's very important for you, your caregivers, and others around you to use good hand hygiene. This means washing your hands well with soap and clean, running water for at least 20 seconds. Or use an alcohol-based hand sanitizer to clean your hands. The sanitizer should contain at least 60% alcohol.

It's also important not to touch the catheter where it enters your skin. And be very careful to keep your work area and supplies clean.

Changing the dressing

Review the steps below and make sure you understand them. Ask your healthcare provider if you and your caregiver can perform the procedure before you are discharged to make sure that you understand what you are to do. If you’re not sure what to do or how to use your supplies, ask a member of your healthcare team before you try to change the dressing.

Note: Since a midline catheter is in your arm, you’ll only have one free arm during the dressing change. This makes it hard to change the dressing yourself. Have someone available to help you.

Step 1: Get prepared

• Wash your hands using soap and water or an alcohol-based hand sanitizer.

• Get your supplies together.

  • Your healthcare team will give you a list of specific items to use. Or you may use a kit that has everything in it.

  • Your supplies may include:

    • Dressing (transparent or gauze)

    • Antimicrobial cleaning swab or sponge

    • Gloves (sterile)

    • Alcohol wipes

    • Sterile drape

    • Medical tape, adhesive strips, or a securement device

• Prepare your work area.

  • Choose an area with a hard, flat surface to lay out your supplies.

  • Clean washable surfaces with soap and water. Dry with a clean, unused paper towel. Then throw the paper towel away.

  • Spread clean, unused paper towels over your work surface to cover it, or use the sterile drape from the kit.

  • Lay out your supplies in the order that you will use them.

  • Open the supplies. If any of the supplies are sterile, remove the plastic covering only.

  • Place a small plastic or paper bag near the work area to dispose of the old dressing and other used supplies.

  • Wash your hands again.

Step 2: Remove the old dressing

• Put on sterile gloves.

• Peel the edges of the old dressing away from the skin. Hold the catheter and pull the dressing upwards. Place the old dressing in a trash bag.

• If you are using a securement device, carefully remove it using the method your healthcare team showed you.

• Check the exit site and the area around it. Call your healthcare team if you have any of the problems listed at the bottom of this sheet.

Step 3: Clean the site

• Remove the gloves you wore in step 2 and throw them away. Wash your hands again and put on a new pair of sterile gloves.

• Clean around the exit site by going around in circles. Using the antimicrobial swab or sponge, start at the area closed to the site and go outward. Use a new cleaning swab and repeat this 3 times or for as many of the antimicrobial swabs in your kit. Let the site dry after each cleaning. Don’t fan the site or blow on it to help it dry.

• Clean the catheter tube with an alcohol wipe, moving the wipe from the exit site to the end of the tube.

Step 4: Put on a new dressing

• If you are using a securement device, apply it as you were shown.

• Apply the transparent or gauze dressing over the exit site. Seal all the edges of the dressing.

• Roll up the catheter tubing loosely and tape it against your skin. Don’t tape on top of the dressing.

• Throw away the old dressing and used supplies.

• Remove your gloves and throw them away.

• Wash your hands.

When to call the healthcare provider

Make sure you know what number to call with questions or problems, even on evenings, weekends, and holidays. Call your healthcare provider right away if you have any of the following:

• Redness, swelling, pain, or drainage at the site.

• Pain or swelling in your arm or shoulder

• Trouble moving your arm

• Bleeding at the catheter site

• Temperature of 100.4°F (38°C) or higher, or as directed by your provider

• Chills

• Catheter that comes out, breaks, cracks, leaks, or has other damage